Range Rebuild Surfaces

This script allows the user to rebuild surfaces that fall within a certain point count range. The user is asked to select a series of surfaces and is then prompted to select a minimum and maximum point count as well as a point count for rebuilding if the surface falls within these parameters. Additionally, the ability to override the degree of curvature is included if the value is zero the existing curvature is retained.

Rhino Script

Option Explicit 
'Script written by <David Mans> 
'Script copyrighted by <Neoarchaic Studio> 
'Script version Tuesday, June 09, 2009 3:07:42 PM 
Call Main() 
Sub Main() 
    Dim curves, arrValue 
    curves = Rhino.GetObjects("Select Surfaces to Rebuild", 8,, True) 
    If isNull(curves) Then Exit Sub
    arrValue = Rhino.PropertyListBox(array("(U) Range Minimum", "(U) Range Maximum", "(U) Point Count", "(U) Degree (0=current)", "(V) Range Minimum", "(V) Range Maximum ", "(V) Point Count", "(V) Degree(0=current)"), array(2, 10, 5, 0, 2, 10, 5, 0)) 
    If isNull(arrValue) Then Exit Sub
    Call Rhino.EnableRedraw(False) 
    Call reBuildRange(curves, array(CInt(arrValue(0)), CInt(arrValue(4))), array(CInt(arrValue(1)), CInt(arrValue(5))), array(CInt(arrValue(2)), CInt(arrValue(6))), array(CInt(arrValue(3)), CInt(arrValue(7)))) 
    Call Rhino.EnableRedraw(True) 
End Sub
Function reBuildRange(arrSurfaces, minVal, maxVal, arrValue, arrDegree) 
    reBuildRange = Null 
    Dim i, tVal(1), tDeg(1),tBln(1) 
    Dim arrOutput() 
    ReDim arrOutput(uBound(arrSurfaces)) 
    For i = 0 To uBound(arrSurfaces) Step 1 
        'calculate for U then V 
        For j = 0 To 1 Step 1 
            'find the existing point count, set rebuild to false 
            tVal(j) = Rhino.SurfacePointCount(arrSurfaces(i))(j) 
            tBln(j) = False
            'if the point count is in range then set rebuild to true and specify new point count 
            If tVal(j) >= minVal(j) And tVal(j) <= maxVal(j) Then
                tBln(j) = True tVal(j) = arrValue(j) 
            Else
                tVal(j) = tVal(j) 
            End If
            'if degree is set to zero use existing surface degree, otherwise specify new surface degree 
            If arrDegree(j) <= 0 Then
                tDeg(j) = Rhino.SurfaceDegree(arrSurfaces(i))(j) 
            Else
                tDeg(j) = arrDegree(j) 
            End If
        Next
        'if both U and V point counts fall within specified range, rebuild surface 
        If tBln(0) = True And tBln(1) = True Then
            arrOutput(i) = Rhino.RebuildSurface(arrSurfaces(i), tDeg, tVal) 
        Else
            arrOutput(i) = arrSurfaces(i) 
        End If
    Next
    reBuildRange = arrOutput 
End Function